This 15 page ebook will guide you how to replace your iPhone display Assembly. Replace the display Assembly Panel, digitizer and LCD give a new windshield. The LCD is stuck on the glass can be singled out in the factory and the two parts without damage.
Step 1 - back
Before of removing your iPhone, be sure that it is switched off
Remove you the two 3.6 mm Pentalobe screws next to the dock connector
Step 2
Press you back on the top of the iPhone. The Panel will move about 2 mm.
Step 3
Remove the back panel from the iPhone.
Step 4 battery
Remove the single 2.5 mm Phillips screw secure the battery connector on the motherboard.
Step 5
-Verwenden you an iPod opening tool carefully the battery connector from the ends of the top and bottom edges of the iPhone to the next lever. Not levers you against the spring contact.
Remove you the pressure contact from iPhone.
Step 6
Use the clear plastic pull tab, to gently lift the battery out of the iPhone.
……
Step 30
En route of the digitizer and LCD cable through internal steel frame. You should before re-fastening the front panel to the inner steel frame both the digitizer LCD cable not folded or trapped between the inner frame and the front plate Assembly. This will cause damage to the cable and without enough slack for them on the main Board. Download Installing iPhone 4 display Assembly
