This iPad Wi-Fi battery installation guide 21 step to get. Check out the step by step instructions and will receive the complete iPad installation guide from its source in the field of information.
Step 1 display Assembly
Place a metal Spudger between the upper edge of the display Assembly and the rear panel mounting. Turning to release the Spudger way you, the tabs at the top of the screen. Place a second metal Spudger between the top of the display Assembly and the rear wall Assembly to prevent the tabs snap engages again.
Step 2
Work the right side of the iPad, tabs with a Spudger your way along share, as you go.
Step 3
Lift the display by the fitting of the rear panel at the bottom of. Do not attempt to remove the indicator at this point, as it is connected to the back Assembly.
The following steps will disconnect the three cables attach the display Assembly to the motherboard. The cables are for the following components:
-Digitizer
-Ambient light sensor
-Display data cable
Step 5
Use the edge of a plastic tool opening, folding flip the retaining clips holding the digitizer flat cable into the socket on the motherboard. Make sure that you cover, not the socket itself reflected the retaining clips are. Pull the digitizer flat ribbon cable directly from their burrows.
