there are 9 steps to follow and 6 pages to install the iPad wi-fi metal show clips guide. Here are some instructions to follow, as shown in the manual for the iPad Manual:
Step 1 - display Assembly
Arrange one metal Spudger between the upper edge of the display Assembly and the rear panel mounting.
Turning to release the Spudger way you, the tabs at the top of the screen.
Arrange you a second metal Spudger between the upper edge of the display Assembly and the rear wall Assembly to prevent the tabs snap engages again.
Step 2
Work the right side of the iPad, tabs with a Spudger your way along share, as you go.
Step 3
-Heben you the display Assembly away from the rear wall Assembly at the bottom of.
Trials you, to remove the display at this time as it is not on the back Assembly connected.
Step 4
The following steps will disconnect the three cables attach the display Assembly to the motherboard. The cables are for the following components:
-Digitizer
-Ambient light sensor
-Display data cable
Step 9-iPad metal of display clips
-Remove while the display Assembly, it is very likely that the metal around the perimeter of the clips breaking that display the Assembly.
-To replace a broken bracket, first the screw Torx T5 fuse the broken base of the clip on the display Assembly.
-Setzen they shaped a new clip on the positioning pins in the display frame, and install the T5 Torx screw to secure the two parts together.
-Wiederholen this procedure for all other broken clips around your display Assembly.
Download iPad Wi-Fi metal of display clips installation guide
